S&G Biometric Lock QuickStart Guide

This QuickStart Guide is designed to show you how to begin using your Biometric Keypad immediately. There are many additional features, which can be found in the full operating instruction document.

Use this QuickStart Guide ONLY if your Biometric Keypad has already been synchronized with the lock according to the procedure on page 6 of the full operating instructions.

Installing the Batteries on a Biometric Lock

• Underneath the bottom of the keypad, you’ll find a raised ridge. Place your finger behind it, pull slightly forward and down to open the battery compartment.

• Snap the connectors onto a pair of fresh Duracell® brand (for best performance) alkaline batteries. The batteries must be alkaline. Orient the batteries in the tray with the connector wires facing up.

• The smaller photo shows proper positioning of the battery cable clip under the cross bar of the battery drawer. The drawer will slide into the keypad much easier if you position the battery cable clip as shown. For clarity, the photo shows the drawer removed from the keypad. However, it is not removable once the keypad is installed on its base.

• Once the batteries are in place, push the tray back up into the keypad until it snaps into place.